Reboot the Pi and you should be good to go! Sign up to join this community. The best answers are voted up and rise to the top.
Stack Overflow for Teams — Collaborate and share knowledge with a private group. Create a free Team What is Teams? Learn more. Ask Question. Asked 1 year, 1 month ago. Active 1 month ago. Viewed 2k times. I'm expecting wlan1 wlan0 is the onboard wifi , however ifconfig doesn't show any new wifi adapter lsusb Bus Device ID b Edimax Technology Co. Improve this question. Going by edimax. V1 drivers specifically state the do not work with the V2 adapter Thank you.
No particula reason. Frankly, I didn't check for the 'V2' term until your answer, seems I'm looking at hassle here. Anymore thoughts? No reason, in contrary: I didn't even consider the term "V2" in my pre-sales research..
Code: Select all ifup wlan0. Last edited by asandford on Sat Jul 26, pm, edited 1 time in total. Re: edimax ewun setup Sat Jul 26, pm i tried the one from fars-robotics, and when i ran Code: Select all sudo ifup wlan0. Re: edimax ewun setup Sat Jul 26, pm doing the one fkp4tr, running Code: Select all sudo ifup wlan0. Re: edimax ewun setup Sat Jul 26, pm joeramsay wrote: i tried the one from fars-robotics, and when i ran Code: Select all sudo ifup wlan0.
Code: Select all sudo ifdown wlan0. Code: Select all sudo ifup wlan0. Code: Select all lsusb. If scan doesn't work, is the adapter showing up with this? Code: Select all auto lo iface lo inet loopback iface eth0 inet dhcp.
Code: Select all allow-hotplug wlan0 iface wlan0 inet dhcp wpa-ssid "network-name" wpa-psk "network-password". All rights reserved. Re: edimax ewun setup Sat Jul 26, pm if you're looking for cu from lsmod, it's there used by 0. Re: edimax ewun setup Sat Jul 26, pm joeramsay wrote: if you're looking for cu from lsmod, it's there used by 0. Code: Select all iface etho0 inet dhcp. Code: Select all iface eth0 inet dhcp.
Code: Select all iface default inet dhcp. The only strange thing was my Netgear router only played ball if I allowed the SSID to be broadcast, not that it should make any difference.
Happy days. What happens is that using an Ethernet connection initially and the latest script file, all goes well until the firmware update happens then, some 10 mins into this the screen goes blank.
However, no matter how long I wait, the screen never return, unless I press a key. At that point the message about inserting the adaptor is there, but of course the adaptor had not been inserted I tried inserting the adaptor during the balnk screen phase, no success. The message on reboot is always that wlan0 could not be found. The adaptor works on a Windows PC.
Any similar problems from anyone? Using a wired link on the RPi, I have no problem connecting. It's very active. I hope this helps.
0コメント